Yes, Industrial Seal Pro is specifically designed to be directly added to your system’s coolant.
Yes, Industrial Seal Pro is compatible with all coolants including brine solutions.
Once installed, Industrial Seal Pro’s particles shrink 15 percent, penetrate and collect at the outside of the leak and build inward, establishing a permanent seal on the outside of the leak.
Results are typically seen within two days, depending on the size of the leak. In most cases the leak will be sealed in one day.
No, Industrial Seal Pro’s™ particles will easily pass through a 24-gauge mesh screen, which is about the same as a household screen door. Note: Shaler recommends using a filtration system on all systems, especially brine-based systems, which are susceptible to corrosion.
No, Industrial Seal Pro™ cannot be used with R–22 or any other type of refrigerants that are used in Direct Refrigeration Systems.
No, all you have to do is mix with water, coolant, brine and introduce it at a rate of one gallon per minute (1 gal/min).
Very easily. Once the product is mixed (see instructions here), add Industrial Seal Pro™ where you normally add glycol or brine to the system.
International: 01-810-603-1324 